Retrofit Master Flash®
  • Use when over the top installation is not an option.
  • Available in EPDM or Silicone (for high temperature application), these flashings are compounded specifically for maximum resistance to weathering due to ozone and ultraviolet light.
  • Includes cable clamp and snap rivets.
  • The base is designed to form a seal on most panel configurations and roof pitch regardless of pipe location.

NOTE: Do not use petroleum based mastics, sealing compounds or paints on collar.

Master Flash is a registered trademark of Aztec Washer.
EPDM
shown
Silicone
shown
MSDS not required
Prod. No.
Pipe Size
Ctn. Qty.
 Compound Ctn. Wt.
101RF
1/2"-4"
5
 Grey EPDM 6#
101RF-S
1/2"-4"
5
 Red Silicone 6#
201RF
4"-9-1/4"
5
 Grey EPDM 8#
202RF-S
4"-9-1/4"
5
 Red Silicone 8#
301RF 9-1/4"-16-1/4" 5 Grey EPDM 14#
302RF-S 9-1/4"-16-1/4" 5 Red Silicone 14#
EPDM
SILICONE
ADVANCED OZONE RESISTANCE tested to ...
70 hours@500 pphm
70 hours@500 pphm
HIGH TEMPERATURE RESISTANCE
tested to ... intermittent
tested to ... continuous

+135ºC (+275ºF)
+100ºC (+212ºF)

+260ºC (+500ºF)
+225ºC (+437ºF)
LOW TEMPERATURE RESISTANCE tested to ...
-55ºC (-65ºF)
-74ºC (-100ºF)
TENSILE STRENGTH minimum ...
10 MPa (1450 psi)
5 MPa (700 psi)
COMPRESSION SET maximum ...
25%
50%
<Back Next>